MT Series Metallic Plastisol Ink
POWERED BY RHINOTECH
- Phthalate Free, Imparting an attractive and sparkling print effect
- Outstanding brilliant metallic jewel ink
- Ideal for printing on white and light-colored garments
In Compliance with CPSIA (Consumer Product Safety Improvement Act) 2008 Section 101 Lead Content in substrates (<300 ppm lead) and Section 108 Phthalates (<.1% DBP DEHP,DINP,DIDP)
Cotton, 50/50 cotton/polyester blends, and some synthetics.
Metallic Jewel Ink/PF-MT Series is metallic jewel ink imparting eye-catching brilliant prints with excellent durability. It is compatible with most plastisol modifiers and additives.
Metallic Jewel Ink/PF-MT Series is formulated for light or dark color fabrics.
Note: Pre-test on actual substrate before any full production run, for adhesion, wash fastness and other desired effects.
Bright, Jewel finish.
Mesh counts 86T- 110T (European 34-44T) are recommended for maximum deposit without straining.
Dual-sensitized direct method photo emulsion or SBQ pre-sensitized photo emulsion or equivalent.
Heat-cure at approximately 380-390°F (160°C) for 2 to 3 minutes. Will not air-dry.
To reduce ink viscosity with RE-704, add 5% or less (by weight of ink). Reducer is to be used very sparingly and only when necessary.
When printing textiles, use a medium hard (65-85 durometer) squeegee.
Metallic Jewel Ink responds to heat. Always store at cool room temperatures below 90°F (32°C). Avoid exposing inks to elevated temperatures before printings.
1- quart (0.945 Liter), 1-gallon (3.78 Liters), 5-gallon (18.9 Liters) containers. *30-gallon (113.4 Liters) and 55-gallon (207.9 Liters)
SAFETY & HANDLING:
Refer to Material Safety Date Sheet (MSDS) for complete information.
WASH UP SOLVENT:
SWG145C – Wash up or equivalent. / SWG305 – Bio Wash up / SW166 – Instant Bio. Wash up.
PF-GL-990 – Glitter Base / RE-704 – Clear Reducer / RE-705 – Curable Reducer
All colors are formulated using non leaded pigments. *Special Metallic colors available upon request. Contact us for more details!